Project:
| View Revisions: Issue #14270 | [ Back to Issue ] | ||
| Summary | 0014270: When changing the Settings from General Availabity to Test and the other way around an error is shown | ||
| Revision | 2010-08-24 10:50 by psanjuan | ||
| Steps To Reproduce | Go to General Setup || Application || Module Management || Module Management - tab Settings and set below values to Test. - when doing a scan for updates, accept versions of the following status or highter = Test - when searching for new modules,accept versions of the following status or higher= Test - Save Go to Installed Modules tab, scan for updates and then you get below attached screen (scan_test.png). do not install anything, press cancel. Go back to General Setup || Application || Module Management || Module Management - tab Settings and set below value to General Availability. - when doing a scan for updates, accept versions of the following status or highter = General Availability - Save Go to Installed Modules tab, scan for updates and then you get below attached screen (scan_ga.png). do not install anything, press cancel. |
||
| Revision | 2010-08-24 10:49 by psanjuan | ||
| Steps To Reproduce | Go to General Setup || Application || Module Management || Module Management - tab Settings and set below values to Test. - when doing a scan for updates, accept versions of the following status or highter = Test - when searching for new modules,accept versions of the following status or higher= Test - Save Go to Installed Modules tab, scan for updates and then you get below attached screen (scan_test.png). do not install anything, press cancel. Go back to General Setup || Application || Module Management || Module Management - tab Settings and set below value to General Availability. - when doing a scan for updates, accept versions of the following status or highter = General Availability - Save Go to Installed Modules tab, scan for updates and then you get below attached screen (scan_test.png). do not install anything, press cancel. |
||
| Revision | 2010-08-24 10:48 by psanjuan | ||
| Description | When changing the Settings from General Availabity to Test and the other way around an error is shown | ||
| Revision | 2010-08-24 10:31 by psanjuan | ||
| Description | Go to General Setup || Application || Module Management || Module Management - tab | ||
| Copyright © 2000 - 2009 MantisBT Group |
 |